Publish Time: 2022-02-22 Origin: Site
Wire saw for concrete has been widely used in the stone industry, machinery industry, and building construction field, mainly for stone mining and processing, reinforced concrete building demolition and trimming, glass, and other hard and brittle materials processing. Next, is the introduction of wire saw for concrete construction points.
Here is the content list:
l Fixed rope saw machine and guide wheel
l Install the rope
l System connection and safety protection technical measures
l Cutting
l Selection of cutting parameters
l The cutting process should pay attention to the problem
Use M16 chemical anchor bolt to fix the rope saw main stand and auxiliary stand, the installation of guide wheel must be stable, and the edge of the wheel must be aligned with the centerline of the stringing hole to ensure the effective cutting speed of the cutting surface, and strictly implement the installation accuracy requirements.
According to the determined cutting form will concrete cable saw according to certain order winding in the active wheel and auxiliary wheel, pay attention to the direction of the rope should and the active wheel drive direction consistent.
According to the site situation, the connection of water, electricity, mechanical equipment, and other related pipelines should be correct and concentrated, and the alignment should strictly implement the safety operation procedures to prevent the machine, people, auxiliary equipment, and materials from being placed in a disorderly manner and causing accidents. Rope cutting process, concrete wire saw machine movement in the direction of the front must be protected with safety protection block protection, and in a certain area set up safety signs to prompt pedestrians do not enter the construction work area.
Start the electric motor, through the control panel to adjust the active wheel lifting tension, ensure the wire saw for concrete is properly taut, supply the circulating cooling water, and then start another electric motor, drive the active wheel to drive the diamond rope rotary cutting. The cutting process must closely observe the stability of the machine base, adjust the offset of the guide wheel at any time to ensure that the cutting rope is in the same plane.
Cutting process by operating the control panel to adjust the cutting parameters, to ensure that the concrete cutting rope saw running line speed is 20m / s or so, on the other hand, the cutting process should ensure a sufficient amount of flushing liquid to ensure the cooling of the wire saw for concrete and grinding down the powder chip away. Cutting operation to achieve stable speed, stable parameters, stable equipment.
If you encounter the occurrence of card rope, broken rope, and other phenomena to have corresponding measures to solve. Safety protection measures must be strict and tight, otherwise, the diamond beads on the broken diamond wire for concrete will fly out like a bullet and hurt people. Therefore, in addition to the necessary protective measures at the scene, all the uninvolved people come and go to observe.
QuanZhou Sang Diamond Tools Co., Ltd reminds you that wire saw for concrete construction needs to strictly comply with the above points.