the cutting noise of diamond saw blade

1. Saw machine failure

abnormal loudness of the spindle reduction box, the major cause is: bearing clearance, need to adjust: gear wear, need to replace: overload operation, need to adjust : spindle box or reduction box loose, need to adjust: bearing loose, need to adjust:

spindle shaft position temperature is too high, the reason is: small bearing clearance, need to adjust: insufficient lubrication, need to oil:Overload operation, need to adjust . improper bearing fit, excessive interference, need to adjust: bearing wear, need more k:
0 spindle reducer oil leakage, the reason is roughly: saw blade installation shaft seal wear, need to replace: this phenomenon is not excluded, will cause high temperature and noise.

2.segment and matrix failure

The voice is extremely sharp, similar to the noise, the reason is: the knife is not sharp, need to open the edge; The blade of the cutting head should be replaced once it is out: the tire body of the cutting head is soft, and the diamond falls off seriously, so it should be adjusted. Additives should be put into clean water cutting or lubricating fluid with a small dose: the welding of the cutting head is not symmetrical; the rubbing matrix needs to be adjusted or replaced; the width of both sides of the cutting head is poor, so that the mixing ratio of the cutting head is less than the specified value; the rubbing matrix needs to be replaced;
. Abnormal cutting sound, obvious rubbing and heaviness, the reason is: the matrix is soft, need to be adjusted; the matrix diameter jump out of tolerance, need to be rounded: